Stainless Steel Tapping Saddles
For water, gas and petrochemical fluids
Drill Saddles stainless steel housing.
Fits all American Pipe sizes, pipe outside diameters ranges for each Size.
WA-Stainless steel drilling saddle, make connections to branch valves, t-joints shut-off valves, pipe and conduit fittings, etc.
Stainless steel drilling saddle can be supplied with branch sizes starting at 1/2 inch to 2 inch. Special branch sizes can be supplied on request. Working range pipe OD from 68mm to 378mm..
Pipe DN 40 up to and including DN 150: 16 bar;
Pipe DN 175 up to and including DN 300: 10 bar
READ MORE: "Stainless Steel Tapping saddles"
TAPPING SADDLE - High Quality Ductile Iron
Fits all American Pipe sizes, pipe outside diameters ranges for each Size.
- Solid, well thought-out construction.
- High quality GGG 50 ductile iron.
- Produced according to DIN 3543, Part 1.
- Saddle is provided with epoxy coating, EWS epoxy according GSK-diridives RAL-G2-662 DVGWW-270, which prevents rust.
- DVGW (G87 e 087) approved.
- Perfect seal through flat O-ring, which is enclosed in the chamber of the alignment saddle. Through a special combination of Oring and flat ring, a two-fold seal is obtained.
- Rubber for ring gasket is NBR.
- Applicable for various types of material, such as asbestos-cement, cast iron and steel.
- Very suitable for pipes covered with polyethylene. When a DTS Saddle is placed, the polyethylene layer does not have to be removed.
- Test report upon request.
- Wide, 100% stainless steel lower bracket.
- Lower bracket provided with a special rubber band.
- Stainless steel, electrolytic zinc plated nuts, to prevent fretting.
- Saddles available from DN 40 up to including DN 600. (American Sizes 2 inch to 24 inch)
- Suitable for alignments under pressure.
Dimensions of DTS Saddle:
- DTS Saddle can be supplied with a tapped service outlet of 1/2” up to and including 2”.
- Special service outlets are available upon request.
- Strap width 60 mm
- Also available with branch according to 1 1/2”
READ MORE: "Ductile Iron Tapping saddles"
Contact us: Westatlantic Tech Corp., 902 455 4455